These bell push buttons can be used with any make of wired doorbell. They can alo be made to work with wireless systems if connected to a Wired to Wirefree Extender - Click here for extenders. The term, Flush Fitting, means that the movement of the bell push button is behind the front plate, so there is always a need to have a hole made behind the plate to accommodate this movement. However, for most of the round bell pushes there are options for oak or mahogany plinths - Click here, or we supply bell pushes and plinth combinations - Click here. When mounted on a plinth, there is no need for a large hole behind, just a hole for wires.
These bell push buttons can be used with any make of wired doorbell. They can alo be made to work with wireless systems if connected to a Wired to Wirefree Extender - Click here for extenders. The term, Surface Mount,, means that the movement of the bell push button is in front the front plate, so there is only the need for a small hole behind the plate to accomodate the bell wire.
These bell push buttons can be used with any make of wired doorbell that is powered by a transformer operating at 8 volts A/C. They should not be use with battery operated chimes or Wired to Wirefree Extenders, since in both cases the light will drain batteries. The term, Surface Mount,, means that the movement of the bell push button is in front the front plate, so there is only the need for a small hole behind the plate to accomodate the bell wire.